Banner

Sampler

    It seems I may be done with sea foam and water… for now.

    I saw a photo that inspired me.

    Pine needles on gravel

    I know, how could this inspire anyone? But earlier I had seen a photo of yellow maple leaves on the grass and was sorta mulling over a painting like that. And I went out in the woods and took a few photos of leaves on the ground.

    But it wasn’t quite jelling in my head until I saw a photo of seaweed. Sargassum I think. It is an ugly brown/orange/green color but at the same time, it just attracted me. And I thought of the maple leaves on the ground. And the pine needles.

    And then I knew what I wanted to paint ~

    The seaweed:

    Sea weed

    Anything can be inspiring!

    My idea was shells instead of pine needles but a dark background like in that photo. There are beaches here covered with shells and some shopping centers use shells instead of gravel. It’s just a thing. I looked at several different photos of all kinds of shells. I went with mostly simple ones.

    I have a hard time making things “messy” and overlapping, so this was my challenge.

    I did a layout in pencil and just started painting. I couldn’t decide if it was better to pencil in shells or just paint them so I did both.

    Seashells on the beach

    When I had a goodly bunch of shells done, I masked the seaweed with Fine Line Mask.

    Watercolor in progress - seaweed and shells

    I had fun using every technique I have learned on the shells. I painted a few solid and lifted lighter lines with a damp oil painting brush. I used the same brush to paint lines on some shells. I painted a few then dampened and “charged” in other pigments – that is dapping a pigment into a puddle of water so the pigment spreads unevenly. It was a challenge.

    As a side note, on another blog I read a recommendation for using nail painting brushes for details in watercolor. These were cheap so I bought them.


    Can’t recommend. They don’t hold water well and don’t hold their shape. Sadly, not worth the 4 bucks unless you just want to try them yourself. For me, it’s a no.

    The oil painting brush works so much better. Any flat brush like this works. Oil brushes don’t hold water well but they are stiff and halfway decent ones hold an edge for painting fine lines or lifting pigment. I know there are special watercolor brushes for fine lines but they take mastery that I do not yet have. I am all for the cheap, easy solution.

    I wanted a textured background so used Fine Line Mask to dot “sand” or pebbles all over. This looks tedious but didn’t take long.

    masking fluid on watercolor paper to create a sand effect

    Here’s a detail of how all this went. No idea how it will come together in the end but that is half the fun.

    Detail of masking fluid on watercolor paper

    No mention of pigments used and I was just taking dibs and dabs of anything and everything on my palette to create the different shell colors.

    For the “sand” I wanted to use Zoisite which is a weird slightly greenish gray. It looked a bit… dull so I floated in some Bloodstone which is a similar gray with a somewhat violet tint. It also read darker than the Zoisite and seemed to give the background more life.

    It was at this point that the whole thing reminded me of an old embroidery “sampler”. School girls used to do these to show all the stitches they had learned. I am showing all the watercolor tips and tricks I have learned – so far.

    However, it was at this point I noticed a problem. There were too many little areas where the background did not fully extend to the shell edges. I confess, I use cheap, synthetic brushes. They work. They also get a bit dull – not coming to a good point – after a year or two. The brushes I was using were not fine enough for the detail I wanted.

    I remembered that last time I travelled across the bridge to buy brushes – one thing I don’t usually buy online – that I had stashed a few extras. I pulled out a new Princeton4350R – a good cheap brush – and the difference was amazing. The tip got into all those little tight corners. Sometimes you just need a new brush; it’s not you, it’s the brush.

    Princeton #4 round brush

    Now to remove the mask and start in on the seaweed. I was at a loss as to how to even start on the color so I gathered Transparent Yellow Oxide, Sienna, Transparent Red Oxide, Transparent Brown Oxide and Serpentine Green and went at it.

    I painted each leaf with yellow then fully wetted it and made puddles of the Serpentine and the oxides. The Transparent Red Oxide granulates all over! In a few places I added the Sienna to give those orange edges. I also colored in a few of the pebbles. The Serpentine Green is one of those Daniel Smith pigments that tends to “separate” out into an almost florescent green and a burnt orange but if you know that, you can use it.

    Serpentine Green pigment


    Here is the finished piece – I don’t think I quite have it but overall, pleased.

    Seaweed on shells

    Buy a print?

    Materials Used


    Note: I am an Amazon Associate and purchasing through these links gets me a few cents (literally) and helps support this blog.


    All pigments Daniel Smith unless otherwise noted:

    Fine Line Masking Fluid

    Leave a Reply

    Your email address will not be published. Required fields are marked *